- Official lithium thionyl chloride battery replacement for Blue Connect smart water analyser.
- Compatible with Blue Connect (white) and Blue Connect Plus (blue) models.
- Approx.dimensions : 13 x 1.5 x 1.5 cm.
- The battery needs to be replaced approximately every two years under normal conditions of use.
- To ensure maximum battery life, it is recommended to put the Blue Connect in standby mode when your pool is in hibernation (see instruction manual for more information).
- 2 year warranty according to manufacturer's conditions.
Steps to follow to replace the battery:
- Under"Parameters" ""Blue Connect", click on"Change battery".
- Take the analyser out of the water, remove the rubber ring and the use cap and place Blue Connect in the storage plug.
- Dry it and start the procedure in a dry, clean place.
- Remove the adhesive tape and unscrew the top of the device. This is a left-hand thread. Unscrew it clockwise. Remove the gasket and discard it.
- Disconnect the white connector by pulling the red and black cable. The battery is at the other end of the cable. Press the plastic rod to release the battery and pull it out by pulling on the cable.
- Place the battery in the bottom of the cavity until it locks into place. Then connect the connector.
- Fit the new gasket supplied with the battery into the thread on the top of the unit. Close the top. This is a left-hand thread. Screw it counterclockwise.
- Stick the new adhesivetape supplied with the battery and put the ring back on. Then put on the use cap and put your Blue Connect back in the water.